Center Bore Size 15x7 Volk TE37

Integra Type-R Discussion - Discuss general ITR information, technical information (including requests for technical/mechanical help/assistance), modifications, tuning, etc.
Locked
JDM FACTOR
New ITRCA Member
Posts: 59
Joined: October 14th, 2009, 9:52 pm

Center Bore Size 15x7 Volk TE37

Post by JDM FACTOR »

Anyone know the center bore size of a 15x7 TE37?
crxgator
ITRCA Member
Posts: 181
Joined: September 16th, 2006, 11:11 pm
Location: Kingston, NY

Re: Center Bore Size 15x7 Volk TE37

Post by crxgator »

for a 15 x 7 + 35, 4 x 100 - it takes a 65mm hubcentric ring. Not sure if it's different 5 x 114.3.

I got this info from Mackin. Email directly.

bduong@mackinindustries.com

*edit, i meant 65*
Last edited by crxgator on October 1st, 2010, 9:28 am, edited 1 time in total.
JDM FACTOR
New ITRCA Member
Posts: 59
Joined: October 14th, 2009, 9:52 pm

Re: Center Bore Size 15x7 Volk TE37

Post by JDM FACTOR »

Thanks crxgator, I ended up taking the rim off and measured with a caliper. It's a 15x7 43mm offset TE37 5x114.3 The center bore was 73mm.
Locked