98-1007 Integra Type R - MN

Post Cars For Sale ONLY
Locked
pennies_integra
New ITRCA Member
Posts: 13
Joined: May 31st, 2006, 10:29 pm

98-1007 Integra Type R - MN

Post by pennies_integra »

Selling 98-1007 ITR. She has around 130k, 2nd owner (owned for 7 years) and clean title with no accidents/thefts.

I will either sell it AS IS for 10k or as a rolling shell for 6k.

As of now, the car has a K24 Frank that made 230 whp and 180 lbs of torque. I barely drove her but the last time I did, it started to have piston slap and I have lost interest in the car. Should be an easy fix as you would probably need to fix the bottom end only. I have yet to open her up but she cranks by hand fine.

Either way, the car will NOT come with the oem rims (steelies) or any front seats and will need to be towed both ways. Other then that, it should be come as following...

AS IS

Engine
K24A1 with TSX pistons/K20Z3 head with aftermarket cams/RBC Manifold
K20Z3 Transmission with OEM LSD and Hybrid racing chip
Hasport mounts
Does have powersteering
Hybrid racing fuel system (Lines, Aeromotive FPR, GE fuel rail)
DSS Stage 2 axles
Hondata Kpro
Hybrid racing wire harness
Hytech Catback
DC Hybrid Header
OEM RSX radiator

Suspension
PIC R3's
Brembo Blanks all around with new pads
New front bearings

Other option

It is a rolling shell and is K-series prepped. It will come with the following...

Exterior:
JDM HID front end
Steelies with the 5 lug

Interior:
Autopower Rollbar
No front seats but will come with JDM ITR rears

Engine Bay:
Hasport K-series mounts
RSX Powersteering
Karcept Shifter Kit

Suspension:
It'll be some type of ITR suspension, haven't made up my mind on which set yet

You will need a K-series swap/fuel system/Kpro/Axles/Exhaust/Intake, etc. I am FIRM on 6K. The front end/5lug/mounts alone is worth over 3k.

Here's some older picture after the paint job, the Mugen wing is gone but will come with the OEM wing. Again, it will come with steelies. It was repainted about 2 years back. Im sure Im forgetting a ton of other things and I will only part her out once the shell is sold. Keep negative comments to yourself or you will be reported.


Older pix right after the paint job

Image

Image

Image

Image

Found some older pictures but the car looks the same minus a few small items. The car is in storage right now so if someone serious wants actual pictures then Ill have to drive to get them


Image

Image

Image

Image

Image

Image

Image
Last edited by pennies_integra on January 9th, 2011, 3:29 pm, edited 1 time in total.
beastnatch
ITRCA Member
Posts: 281
Joined: March 7th, 2008, 3:31 pm
Location: Oregon
Contact:

Re: 98-1007 Integra Type R - MN

Post by beastnatch »

GLWS! At least if she goes as a shell, she is "nearly complete".
2001 Integra Type-R NBP #201
http://www.integratyper.org - ITR Registry!
pennies_integra
New ITRCA Member
Posts: 13
Joined: May 31st, 2006, 10:29 pm

Re: 98-1007 Integra Type R - MN

Post by pennies_integra »

Thanks
Locked