![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
Cam Gears for 2001 ITR?
-
- New ITRCA Member
- Posts: 9
- Joined: November 1st, 2002, 8:10 pm
- Location: St Louis
Cam Gears for 2001 ITR?
I have a 2001 ITR w/ an AEM CAI, is it worth spending some dough on some cam gears? Which one is better? Is there really a difference between any of them? What should I retard or advance the timing to? ![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
![Rolling Eyes :roll:](./images/smilies/icon_rolleyes.gif)
-
- New ITRCA Member
- Posts: 9
- Joined: November 1st, 2002, 8:10 pm
- Location: St Louis
-
- New ITRCA Member
- Posts: 9
- Joined: November 1st, 2002, 8:10 pm
- Location: St Louis
I'd recommend Toda's cams, only because they specifially made them for ITR's (said it once, say it again). As for the header, I've always thought of going Mugen (4-2-1). However, some point out that 4-1 is better (but I'm still going 4-2-1. Also, Hytech Headers have been referred to me as well.
'98 Acura Integra Type-R
'03 Honda CBR600RR
Surgeon General's Warning: It's OK to Smoke V8's
'03 Honda CBR600RR
Surgeon General's Warning: It's OK to Smoke V8's
Cam gears are good if you plan on doing some tunning, but not as a second mod, get some other boolt on stuff first, otherwise you'll find youself back at the dyno more often then you'd like.
And about the skunk2 cam gears markings being off, it's tru, mine were off by almost 1.5 degrees. Don't know what to say.....
Any cam gear is good, as long as it has 4 or more bolts locking it down.
Later!
And about the skunk2 cam gears markings being off, it's tru, mine were off by almost 1.5 degrees. Don't know what to say.....
Any cam gear is good, as long as it has 4 or more bolts locking it down.
Later!