17's for the R

Integra Type-R Discussion - Discuss general ITR information, technical information (including requests for technical/mechanical help/assistance), modifications, tuning, etc.
Locked
K20Death
New ITRCA Member
Posts: 31
Joined: May 30th, 2003, 10:36 pm
Location: OKC, OK

17's for the R

Post by K20Death »

Is their a certain off-set that is better when putting 17's on the ITR. Im about to order some WORKS Emotion CR's and they come in an offset of +42 or +47. Any information would help out alot.
nightrider
New ITRCA Member
Posts: 31
Joined: September 28th, 2003, 6:21 pm
Location: Seattle, WA

Post by nightrider »

the only information i would give you is to not order 17's for the R. :roll:
K20Death
New ITRCA Member
Posts: 31
Joined: May 30th, 2003, 10:36 pm
Location: OKC, OK

Post by K20Death »

Somtimes wheels can make a car look better contrary to what people tell you to do with your ITR. Stocks get old after awhile.
nightrider
New ITRCA Member
Posts: 31
Joined: September 28th, 2003, 6:21 pm
Location: Seattle, WA

Post by nightrider »

well 17's do provide a worse ride quality so that's one of the reasons, but not the more underlying issue such as being conventional for racing or whatnot. last, but not least my R will be faster than yours!! :mrgreen:
00-1526 FBP JDM front-end
K20Death
New ITRCA Member
Posts: 31
Joined: May 30th, 2003, 10:36 pm
Location: OKC, OK

Post by K20Death »

nightrider wrote:well 17's do provide a worse ride quality so:
Im pretty sure 17's provide better ride quality..?
nightrider wrote:of the reasons, but not the more underlying issue such as being conventional for racing or whatnot. last, but not least my R will be faster than yours!! :mrgreen:
Do you race your car everywhere you go? Most people dont and when they do decide to take their car to the track stock's with good rubber are superb. And if you really think a 2 inches is going to make a stock ITR faster than an ITR with 17's then your not very smart; the 17's Im getting weigh 2 lbs more than stock ITR rims. :roll:
CanadianR
New ITRCA Member
Posts: 18
Joined: March 15th, 2003, 3:54 pm
Location: Edmonton

Post by CanadianR »

K20Death wrote: Im pretty sure 17's provide better ride quality..?
No, actually they will be a bumpier/stiffer ride as the sidewall will be shorter and will cause a more jarring ride than a smaller wheel with more tire sidewall will. the handling may be improved, but that's mostly due to the increased width over a stock wheel
K20Death wrote:Do you race your car everywhere you go? Most people dont and when they do decide to take their car to the track stock's with good rubber are superb. And if you really think a 2 inches is going to make a stock ITR faster than an ITR with 17's then your not very smart; the 17's Im getting weigh 2 lbs more than stock ITR rims. :roll:
actually he IS right. The aftermarket 15" wheels most itr owners buy are 2-7 pounds lighter than the stock wheels. Plus, even a 17" wheel that weighs exactly the same as a 15" wheel will still be "heavier" when accelerating to to more mass being spread out further from the center of the wheel. It's likely not a huge difference, but he still is correct.


As far as offset goes, it really depends on the width of the wheel you are getting, i would "guess" that if it's a 17x7" wheel either the 42 or the 47 would be alright, but 47 is closer to stock offset. If it's a 7.5" wheel i'd say you'd need to go with the 47 ET.
nightrider
New ITRCA Member
Posts: 31
Joined: September 28th, 2003, 6:21 pm
Location: Seattle, WA

Post by nightrider »

two words to wrap of what the guy before said:

rotational mass

Emerika knows what I'm talking about if he's on this board. ha haha. :mrgreen:
00-1526 FBP JDM front-end
Locked