compression test on JDM B18C R?

Discuss national (except for the ITR Expo), regional and local events and meets here.
Locked
Enemy
New ITRCA Member
Posts: 2
Joined: September 14th, 2004, 1:31 pm
Location: TEXAS

compression test on JDM B18C R?

Post by Enemy »

When you do a compression test on your B18C R
what ratings or numbers are you suppose to get?
Bbasso
Post Whore!!
Posts: 6571
Joined: September 25th, 2002, 1:21 am
Location: South Carolina !
Contact:

Post by Bbasso »

I did a test on my stock usdm motor and got between 230 and 235 for all four.
the key is not to have to much variation (sp?) between them.
swed
Enemy
New ITRCA Member
Posts: 2
Joined: September 14th, 2004, 1:31 pm
Location: TEXAS

Post by Enemy »

Thanks for the reply

Yesterday the compression test was done and got over 300 on each cyc.

The motor was just purchase and the seller said that the engine is
practically new. Its a 2000 JDM motor - does this sound right
ITRacer121
New ITRCA Member
Posts: 70
Joined: November 11th, 2002, 11:54 pm
Location: Texas
Contact:

Post by ITRacer121 »

that is weird? my USDM did 230 all across...then I put in high compression valves and milled the head and im only doing 265 across?

I would check a different compression tester
Heps
New ITRCA Member
Posts: 7
Joined: May 1st, 2005, 11:34 pm
Location: Regina

Post by Heps »

Yeah that seems to be a bit high, I have 220 across all my cylinders
ITR # 381
Trev-R
New ITRCA Member
Posts: 30
Joined: January 8th, 2007, 10:47 pm

Post by Trev-R »

I have a B18C-R and it did 250 across, you must have something in there to make 300 across.
Locked