Floor jack position

Integra Type-R Discussion - Discuss general ITR information, technical information (including requests for technical/mechanical help/assistance), modifications, tuning, etc.
Locked
TypeRPaul
New ITRCA Member
Posts: 31
Joined: September 16th, 2002, 4:17 am
Location: San Jose

Floor jack position

Post by TypeRPaul »

I was just wondering if there is a good place to put a floor jack up on a 01 itr and where it would be...i know where to jack up with the reg jack in the car.....but then where to put the jack stans....any help would be appreciated...thanks
01 nbp ITR
-AEM CAI
-Apexi N1 cat-back exaust
Bbasso
Post Whore!!
Posts: 6571
Joined: September 25th, 2002, 1:21 am
Location: South Carolina !
Contact:

Post by Bbasso »

If you use the tow loop in the rear you will be fine. It can handle the weight and will lift both rear tires. Just be sure to use jack stands to support the weight.
swed
Trey
Site Admin
Posts: 1004
Joined: September 10th, 2002, 11:43 pm
Location: TN
Contact:

Post by Trey »

You can also find a jack point in the front of the car just under the radiator support. It will be just past the plaustic undertray and be in a cutout area.
Aj
Senior ITRCA Member
Posts: 801
Joined: September 17th, 2002, 7:39 pm

Jack position

Post by Aj »

You can also use the tow hooks in front even though you can;t se them unless the car is jacked up, they are easily accesable when the car is in the air, and are pretty out of the way. Either that or you can use any where on the subframe, or regular parts of the frame.

Good Luck...

Aj
bbqman
Canadian Director
Posts: 485
Joined: October 1st, 2002, 12:44 pm
Location: Montreal
Contact:

Jacking

Post by bbqman »

Btw, with the chassis so rigid, you can also jack the car up using the front rocker panel point.
This raises the car with both wheels at the same time.Useful when swapping wheels or when the car is too low for the before mentioned front rad mount point and rear tow hook point.
Locked