Exhaust comparison question

DCR26 · Post by **DCR26** » June 23rd, 2007, 6:32 pm

How does the Mugen twin loop exhaust system compare to the Buddyclub pro spec 3 exhaust and Tanabe Super Medalion systems as far as performance and sound is concerned?

SerGTR · Post by **SerGTR** » June 25th, 2007, 2:03 am

AS of wat I know of it is more havier, quieter than other two yet it could be just slightly less flowing but still very good because of special twin loop system.

junkyard racer · Post by **junkyard racer** » June 25th, 2007, 11:49 pm

from what ive been told, the Mugen twin loop bottles down big time inside that canister. It was made for more of a sound aspect rather than a performance aspect. It does sound super sexy, enough that I would give up a hp or two to have it.

The BC exhaust is

loud, but also sounds sexy.

Tanabe is sexy sounding, I cant speak on the performance though.

If I had to choose between the two, id pick the twin loop.

Twin loop = super sexy sound, a little less hp
BC = straight exhaust, loud, picks up some HP though.
Tanabe = I dont know anything reguarding performance, but I know they sound sexy.

Dave_B · Post by **Dave_B** » June 26th, 2007, 9:23 am

I have the TL and I think it's a pretty decent piece.

Sound is ok, not loud but not to my taste. I would have prefered something a little more "throaty" but it's not raspy either.

I too have heard they are a bit heavier, but so is the Hytech.

get RIGHT · Post by **get RIGHT** » June 26th, 2007, 11:39 am

Also look into the fujitsubo RM01A.

Very quiet, lightweight, makes good power.

soulassassin13 · Post by **soulassassin13** » June 26th, 2007, 5:49 pm

I want the Futsujibo so badly just becuase it looks do damn sexy, but I haven't seen any test/dyno results on it.

SerGTR · Post by **SerGTR** » June 26th, 2007, 11:03 pm

I am hardly debating on either fujitsubo RM01A or T1R, they cost about the same, look about the same, weight about the same, not sure about sound...

soulassassin13 · Post by **soulassassin13** » June 27th, 2007, 12:56 am

I went with the Buddy Club III, but I won't know the real result until my HyTech header comes back from the shop.

Bbasso · Post by **Bbasso** » June 27th, 2007, 1:03 pm

http://www.itrca.com/forums/viewtopic.p ... ight=bciii

LOUD!

SerGTR · Post by **SerGTR** » June 27th, 2007, 3:15 pm

fujitsubo RM01A quiet

http://www.youtube.com/watch?v=SR-uRZ-ljvs

Post by **Doespike** » June 27th, 2007, 3:47 pm

SerGTR wrote:fujitsubo RM01A quiet
http://www.youtube.com/watch?v=SR-uRZ-ljvs

oo, I like that one

Erik95LS · Post by **Erik95LS** » June 27th, 2007, 10:16 pm

Doespike wrote:
SerGTR wrote:fujitsubo RM01A quiet
http://www.youtube.com/watch?v=SR-uRZ-ljvs
oo, I like that one

you should poast your HyTech vids from expo

Post by **Doespike** » June 27th, 2007, 10:25 pm

Erik95LS wrote:
Doespike wrote:
SerGTR wrote:fujitsubo RM01A quiet
http://www.youtube.com/watch?v=SR-uRZ-ljvs
oo, I like that one
you should poast your HyTech vids from expo

Good idear! Those HyTech's did sound great!

Just a couple flybys.....

Dave B not a HyTech....Dave can fill you in more....but it ain't street legal

Erik95HytechFTMFW!!
WalkerHytechFTMFW!!
Another Jimbo clip

DCR26 · Post by **DCR26** » June 29th, 2007, 4:29 am

Whats the difference between the Buddyclub Prospec and the Buddyclub prospec III?

KetteringITR · Post by **KetteringITR** » June 29th, 2007, 9:09 am

Im assuming you mean the Spec III and the Prospec. For one, the Prospec is slightly quieter than the Spec III however thats not saying much considering the Spec III is rather loud to begin with. Also, someone could correct me here if im wrong, but i believe that the Prospec was designed specifically for the American market (length of exhaust and such). The Spec III is a little bit lighter but all in all from what ive read, the two are very similar.

I was trying to make the same decision and i think i found quite a few posts about it on HT. Try searching buddy club or spec or prospec and im sure youll find what ure lookin for.

Dave_B · Post by **Dave_B** » June 29th, 2007, 9:55 am

Doespike wrote:
Just a couple flybys.....

Dave B not a HyTech....Dave can fill you in more....but it ain't street legal

SMSP 1 piece header, SMSP Race Exhuast which consists of a collector merge, 2' of 2.5" piping, then an 18" resonator and out of the resonator an angled dump t00b. LOL Yes, loud as HELL... Anyone at Expo could tell ya. You knew when I was out on track.

Post by **Doespike** » June 29th, 2007, 11:25 am

Dave_B wrote: LOL Yes, loud as HELL... Anyone at Expo could tell ya. You knew when I was out on track.

This is a fact. For the clip of Dave I shot, I knew he was approaching about 10 secs before the video starts, coming around the turns and building.

Loud, but sounds awesome!

Dave_B · Post by **Dave_B** » June 29th, 2007, 11:46 am

I like the sound myself, though I think I'll be getting a set of ear plugs for the next event. LOL

walker111 · Post by **walker111** » June 29th, 2007, 3:17 pm

HYTECH FTMFW!!!!!!!!!!!!!!!!!!!!!!

silver · Post by **silver** » June 29th, 2007, 3:36 pm

i have the fujitsubo power getter and i'm extremely happy wiith it. should be very similar to the rm01a in sound

SerGTR · Post by **SerGTR** » June 29th, 2007, 9:22 pm

silver wrote:i have the fujitsubo power getter and i'm extremely happy wiith it. should be very similar to the rm01a in sound

how are they differ anyways I mean "power getter" and "rm01a"?