How much whp?

v t e c 2 3 · Post by **v t e c 2 3** » May 9th, 2003, 3:11 am

how much whp does the itr make bone stock?? and how much torque?

jetydosa · Post by **jetydosa** » May 9th, 2003, 8:51 am

Ive seen everything from like 156ish/112ish to 163ish/118ish.

There used to be a page, Integra Dyno Center that had all sorts of dynos of Integras including Rs, but it has moved and the new page just seems to pop up ads everywhere. There are some stock ITR dynos on http://www.bseries.net/html/dyno/NA.php as well to check out.

George Knighton · Post by **George Knighton** » May 9th, 2003, 9:31 am

My car was 158 bone stock, on a Dynojet.

Victor's '97 was 162 bone stock, on the same dyno on the same day.

Post by **Trey** » May 9th, 2003, 12:25 pm

I had one dyno 168/121 and one Dyno 160/116 on the same dyno. they were 2000 and 1998 models respectively.

Aj · Post by Aj » May 10th, 2003, 4:32 am

Mine dynoed at 165.1whp with 121.2 ft/lbs. That was on the Dyno Jet at Street Rods and Classics, who turned out to be mad shady, for any one thinking of going there, beware!!!

Later,
Aj

descartesfool · Post by **descartesfool** » May 10th, 2003, 11:15 am

For a few dyno curves on Integras, you can check out the two following sites:

http://www.dynocenter.com/home.html

and the 1.8 Litre section of the dyno charts section at

http://www.importreview.com/main.html

However if you aspire to truly aspirate some serious quantities of air for some scary hp numbers, check out this site. I think they make 168 hp at idle!

http://www.z06vette.com/perfdata.php

Just put two 4 cylinder motors in.