How fast is a stock ITR?

DC2R1216 · Post by **DC2R1216** » May 6th, 2007, 10:31 pm

14.3 at 97mph with 2.2 60 foot the one and only time to the strip with it. full interior. no ps or a/c

intake, dc header (what it came with when i bought the car), test pipe, hondata img, s300 street tuned

Major_Wolf · Post by **Major_Wolf** » May 6th, 2007, 11:37 pm

DC2R1216 wrote:14.3 at 97mph with 2.2 60 foot the one and only time to the strip with it. full interior. no ps or a/c

intake, dc header (what it came with when i bought the car), test pipe, hondata img, s300 street tuned

wow ,yesterday i did 14.81 at 97 with 2.3 60 foot so i think my 60 foot is bad.I must do 2.1 or 2.2

Mary · Post by **Mary** » May 10th, 2007, 11:04 am

I hope I will try do to some times with my integra this summer, but I heard it is very hard on the mecanic to go on the quarter mile and I don't wan't hurt my car

itr710 · Post by **itr710** » September 28th, 2007, 8:22 pm

i've done 14.65 with my itr, I've done only 5 run and that was my best.

60 foots sucks, 2.304, 97.6 mph

I had a 4-1 jdm oem header with a test pipe, spoon air filter (only the yellow sponge!)

It was my first time at the drag, I really think it can runs low 14 with that setup...

w00ted · Post by **w00ted** » July 18th, 2008, 2:14 pm

did 13.8 @ 99mph once... with my stock engin... but I was more in the 14.2...

guess I had wind in the back the day I did 13.8 lol

HB_BiggyBear · Post by **HB_BiggyBear** » July 30th, 2008, 6:48 pm

14.'s for a Type-R sounds REALLY slow to me. I thought they where much faster!

Dave_B · Post by **Dave_B** » July 31st, 2008, 9:26 am

HB_BiggyBear wrote:14.'s for a Type-R sounds REALLY slow to me. I thought they where much faster!

For a stock car, putting down around 165 WHP from the factory and weighing in at around 2600 LB's isn't bad at all.

As mentioned in your other thread... ITR's are not, never were and aren't the best drag race cars. Honda's Forumula One team was involved with the R&D... it's setup out of the box for road racing.

bos_dc2 · Post by **bos_dc2** » May 24th, 2009, 10:32 pm

ITRnightrider · Post by **ITRnightrider** » July 7th, 2009, 8:18 pm

13.8 at 101mph with just some simple upgrades and also dumped a lot of weight.

8lb flywheel and ACT 5puck clutch
Eagle H-beams (weighted w/crank n flywheel)
toda cams
toda itb's
generic 4-1 header w/ 3" custom straight pipe w/DC muffler (no cat or resonator)

bought a JRSC kit and with my setup i have planned, hopefully ill be close to 300whp and running 12's

eg00typer · Post by **eg00typer** » September 16th, 2009, 7:34 pm

how about the one's with stock bottom end and a built head...Will that work and has anyone done before.

Slick · Post by **Slick** » February 13th, 2010, 4:46 pm

I did 13.97 @ 99.22 mph in a 01 CW ITR.
Mods were, removed intake resonator (wheel well big white box), advance timming (18 degrees BTDC), removed PS belt, spare tire, jack, rear panel.
It was back up by a 13.98 @ 99 mph 1 hour later !

I Dynoed at 171 WHP and 119 WTQ with the exact same setup.

Tires were DOT Toyos, 205/50-15 with 15 psi.

(I weigh 190 lbs)

ITRCA

How fast is a stock ITR?

1/4

Re: How fast is a stock ITR?

Re: How fast is a stock ITR?

Re: How fast is a stock ITR?

Re: How fast is a stock ITR?

Re: How fast is a stock ITR?

Re: How fast is a stock ITR?

Re: How fast is a stock ITR?