NEED HELP WITH CHOOSING NEW WHEELS (OFFSET)

Integra Type-R Discussion - Discuss general ITR information, technical information (including requests for technical/mechanical help/assistance), modifications, tuning, etc.
Locked
SOLOITR2001
ITRCA Member
Posts: 131
Joined: February 1st, 2007, 12:09 am
Location: Phoenix AZ

NEED HELP WITH CHOOSING NEW WHEELS (OFFSET)

Post by SOLOITR2001 »

Ok so I decided on going with these wheels. The Gram Light 57 Maximum Pros

Image

I am going to go with a 17x7 wheel. But I am going to need your guyses help choosing an offset that will fit with my big brake kit from Rotora. These are my options.

http://www.upgrademotoring.com/wheels/g ... um_pro.htm

I have a set of 18x8 Axis Widetracks 50mm lip on right now. I cant lower my car any lower or else the tire will rub on the fenders. My tire and wheel stick out past my fender by about an inch. I also had to use a really thin spacer so it barely fit without rubbing.
Last edited by SOLOITR2001 on November 27th, 2009, 7:03 pm, edited 1 time in total.
coolhandluke
401R
Posts: 2489
Joined: December 12th, 2005, 2:36 pm
Location: SC
Contact:

Re: NEED HELP WITH NEW WHEELS

Post by coolhandluke »

Post up as much information on the brake kit from Rotora. I will say it will be difficult to give you exact advice since many here have not run the Rotora setup. Any reason for this brake kit?
WTB: ODB1 VTEC Distributor!!!!!!!!!!!

2011 ITR Expo Calendar
http://www.itrca.com/forums/viewtopic.php?f=33&t=12472
SOLOITR2001
ITRCA Member
Posts: 131
Joined: February 1st, 2007, 12:09 am
Location: Phoenix AZ

Re: NEED HELP WITH NEW WHEELS

Post by SOLOITR2001 »

Ok this is what is on their application sheet

INTEGRA (TYPE R) 97-01 DC2

F = Front

RBK006.01AC = Part #

Caliper
4 = Caliper Pistons

FC4-A = Caliper Type

Disc
295X23 = Disc Size (MM)

1-PIECE = Disc Type

Wheel Chart
25 = A (MM)
174 = B (MM)
96 = C (MM)
Locked