Page 1 of 1
Hytech exhaust
Posted: February 24th, 2003, 12:27 am
by JMUtype-r
I have a 2001 Type-r and im looking into the hytech exhaust. I know it is pretty expensive but i also know that it is well worth it. I have a AEM CAI now and was wondering what kind of gains i would get with the Hytech exhaust. HP and any other gains
Thanks
Posted: February 25th, 2003, 8:57 am
by Trey
Are we talking headre and cat back or just the cat back?
Also I think there are a few options that will make as much power for less money.
Posted: February 25th, 2003, 1:58 pm
by JMUtype-r
The entire header exhaust system
Posted: February 26th, 2003, 2:13 am
by itr
Trey wrote:Are we talking headre and cat back or just the cat back?
Also I think there are a few options that will make as much power for less money.
what would make as much power???
Posted: February 26th, 2003, 8:14 am
by Trey
Well from all the plots and info i have seen an SMSP or Toda header makes as much power. Exhaust wise just about anything can make power SMSP makes an exhaust, Type 1 Racing just came out with a 63mm inner diameter setup. Headers will be the place power varies and so far Hytech just costs more than the other top power makes.
If I were to buy something other than a JDM 4-1 I would buy a Toda or SMSP depending on the cost.
Posted: February 27th, 2003, 2:16 am
by ITR862
I agree. I am thinking about either the Toda or SMSP header, a Carsound or SMSP cat, and either the SMSP or the new T1R exhaust. The good thing about the Toda is that you can get them pretty quick. The SMSP there is like a 3 month wait. The thing I like about the new T1R is that it is a true 2.5 inch piping with no bottlenecks. I dont care for Hytech cause of personal reasons which I wish not to get into here. For all of that info you will have to visit another Honda forum site which will remain nameless but I am sure most people on here know about.
Posted: February 27th, 2003, 8:32 am
by Trey
ITR862 wrote:I agree. I am thinking about either the Toda or SMSP header, a Carsound or SMSP cat, and either the SMSP or the new T1R exhaust. The good thing about the Toda is that you can get them pretty quick. The SMSP there is like a 3 month wait. The thing I like about the new T1R is that it is a true 2.5 inch piping with no bottlenecks. I dont care for Hytech cause of personal reasons which I wish not to get into here. For all of that info you will have to visit another Honda forum site which will remain nameless but I am sure most people on here know about.
SMSP is a 3 WEEK wait according to David. Figure a month. Hytech is the place that can't seem to deliver . . .
Posted: February 27th, 2003, 3:00 pm
by Austin
Trey wrote:SMSP is a 3 WEEK wait according to David. Figure a month. Hytech is the place that can't seem to deliver . . .
Thanks for the mud slinging Trey...HyTech is a very busy shop, that's all that I'm going to say.
I like my HyTech products...I didn't have any problems other than getting parts that were so new they were still basically second generation prototypes.
SMS makes good products...my point is to purchase what works best for you.
Posted: February 27th, 2003, 3:43 pm
by Trey
Austin wrote:Trey wrote:SMSP is a 3 WEEK wait according to David. Figure a month. Hytech is the place that can't seem to deliver . . .
Thanks for the mud slinging Trey...HyTech is a very busy shop, that's all that I'm going to say.
I like my HyTech products...I didn't have any problems other than getting parts that were so new they were still basically second generation prototypes.
SMS makes good products...my point is to purchase what works best for you.
Sorry Austin. Wasn't trying to overs state what i have seen. I have a friend that waited 9 months for a header for an Si. Just being honest. I have spoken to both people, I have not bought from either and I have priced both and seen the gains from both.
I recommend everyone go learn about the equipment performance and cost and weigh the personal experiences with a grain of salt.
That is as diplomatic as I can put it.
Posted: February 28th, 2003, 12:35 pm
by Austin
Trey wrote:
Sorry Austin. Wasn't trying to overs state what i have seen. I have a friend that waited 9 months for a header for an Si. Just being honest. I have spoken to both people, I have not bought from either and I have priced both and seen the gains from both.
I recommend everyone go learn about the equipment performance and cost and weigh the personal experiences with a grain of salt.
That is as diplomatic as I can put it.
He's more up to speed on the Integra parts...but I can understand, 6 months for a header(production header #1) and 1 year for the exhaust(production exhaust #2). I got into this before most people were aware of HyTech, and SMS wasn't making a whole lot of parts yet.
Austin