ITRCA

if i posted in the wrong place.. sorry erase if need to


I been having a problem with my doors.. they wont completely close until i slam them... and it seems like an inch a way to completely fit it... i have been cutting and cutting and had gotten really close to making it fit right.... its just my doors.. and its putting a lot of stress on my dash... what can i do to make it fit better.... i know that the integra door dont fit my Civic 92 HB and i already have two integra dash just in case i missed up... can any one help me...it a 94-00 integra GSR and Type r dash... let me know

We shoved an ITR dash into an EG hatch, but we couldn't get it to fit without cutting out that part of the door pannel. What we finally did was just cut out that section of the door where the dash would ordinarily fit, and then just fiberglassed it by stretching some felt over the portion left with no door pannel, so this way it had a shape instead of just looking all messy, then glassed over it, after a like an eight of an inch of glass, or about 3 layers, we sanded it down very lightly, as to not disrupt the structure of it, but enough to paint it without it looking like a hack job. It came out really nicely. I'd send pics, but we have the car in pieces and are planning to do it in carbon this go around.

Hope that helped. Later,
Aj