ITRCA

YES YES YES...I finally got my hondata put in with greddy 720cc injectors and intank pump. I'm running a stock head gasket and stock motor. We didn't want to push it to much. We made 306whp (SAE) and 225lbs of torque @ 10psi. Props to Kenny at Jotech Motorsports for helping me reach my 300whp goal on a stock motor. As soon as my scanner stops tripping I'll get my dyno sheet scanned and posted.

Nice!
Good to hear what I have to look forward to. Can't wait to see some time slips.

Thanks Jan. Long time no hear from you BTW....working?

Just normal hours, but I'm on my last semester at school, a lot of studying....and homework. Plus I've been working on my 95 Talon turboI did a 1G motor swap and just got that running yesterday, I'm getting ready to put the R away for the winter. If everything goes right I should be Hondata tuned by January.

Erik B wrote:YES YES YES...I finally got my hondata put in with greddy 720cc injectors and intank pump. I'm running a stock head gasket and stock motor. We didn't want to push it to much. We made 306whp (SAE) and 225lbs of torque @ 10psi. Props to Kenny at Jotech Motorsports for helping me reach my 300whp goal on a stock motor. As soon as my scanner stops tripping I'll get my dyno sheet scanned and posted.

How come you needed 720 injectors....450's would have been fine up to 350whp.

up to 350whp...then what?

I was shooting for 300whp (on a stock block) but that is not my final goal

AH Ha! I see now...
Either way those are some great numbers.

Good luck

thanks bro.

very impressive!

whats your turbo set up? If you dont mind telling..

T3/T04e
Rev hard cast iorn mani
XS FMIC
Greddy 720's
Hondata s200b
2.5 to 3 inch DP
3 inch exhaust

Nice. Hopefully I will be hondata tuned also.

Damn man great numbers.