Page 1 of 1
Help on turbo
Posted: February 25th, 2007, 6:30 pm
by ausrim
I just had this car with 105,000 miles on it, 2001 Acura Integra Type-R. I need everybody's opinion if it's worth putting turbo or rebuilt the engine first .
Re: Help on turbo
Posted: February 25th, 2007, 8:24 pm
by Jan Niemi
ausrim wrote:I just had this car with 105,000 miles on it, 2001 Acura Integra Type-R. I need everybody's opinion if it's worth putting turbo or rebuilt the engine first .
Personally, I'd put in some forged rods and pistons and give it a hone and new bearings prior to boosting it.
You could just turbo it the way it is, but it's up to you.
Posted: February 25th, 2007, 11:20 pm
by ausrim
Thanks Jan...If I turbo it how much boost I can put on my stock. Is ITR's pistons and connecting rods are forged?
Posted: February 26th, 2007, 12:11 am
by soulrider4ever
I wouldn't run any more than 10psi on a stock ITR motor...
Posted: February 26th, 2007, 12:44 am
by Jan Niemi
ausrim wrote:Thanks Jan...If I turbo it how much boost I can put on my stock. Is ITR's pistons and connecting rods are forged?
no the stock parts aren't forged like you think.. the rods might be powder forged, not like the aftermarket forged rods.
I wouldn't so much concentrate on how much boost, because that can be quite subjective. The key is how much power.. my pistons failed at 295whp after about 40K miles of hard driving and over 100 1/4 mile runs. I'm not saying yours will fail too..but ring land failure is pretty common on stock honda pistons at around 300 whp. I'm actually quite happy that my stock motor lasted as long as it did.
Even with a great tune, there's always a chance that you get some bad gas..
Posted: February 26th, 2007, 12:45 am
by ausrim
thanks Soul.....did you modify any internal stuff on yours on 10 psi of boost, I think I should go with forged like Jan said just to be safe, I just don't know what brand I should consider.
Posted: February 26th, 2007, 12:48 am
by ausrim
Thanks for the info Jan.....what brand of forged I should get?
Posted: February 26th, 2007, 9:38 am
by soulrider4ever
Yea, I'd definitely take Jan's advice, he's been boosted a lot longer than I have. And yes, it's about how much power you make...if you get a big fatty turbo, then your better off with 6-7psi, and will probably make 300whp.
I'd def. go forged internals and rods, and a set of ARP headstuds.
Posted: February 26th, 2007, 10:13 am
by ausrim
Thanks for the advice guys!... that's was a big help, especially on a newbie like me, see you guys around.