2000 Integra Type R #1070 Northern Virginia
Posted: May 18th, 2007, 12:49 pm
Listing my 2000 ITR, entertaining the idea of getting rid of it.
JH4DC231XYS004242
124,000 miles
Mods:
Engine
Stock internals
Mugen Intake
Toda Header
Hytech Exhaust with Renault cat
Hondata IM gasket
VAFC
Tuned professionally by Jack at P1!
Transmission
JDM spec trans
4.7 FD
Cusco Clutch-pack differential
Skunk2 Shifter
Skunk2 Knob
Suspension/Brakes
Mugen Lowdowns
Mugen front strut bar
Password rear strut bar
Spoon Calipers w/Cobalt GT's and Autozone rotors front/rear
Stainless Steel brakelines
Safety
Autopower Rollbar
Certified Padding
Interior
Stock Front Seats
Stock Rear Seats
Stock Headunit
JDM Foglight switch
Aftermarket Speakers infinity front/ MB Quart rears
Two sets of floor mats- Black/Checkered
Exterior
Stock
Stock wheels
USDM Foglights
Spare set of JDM Gunmetal 16's
History- Some spoiled rich kid had it before me, commuted to and from college with it. Had some jenky springs and a DAC intake when I recieved it. Ever since my ownership its been meticuously maintained.
The bad- Car has the normal rock chips on the front end, couple of door dings, but still looks great clean. The drivers side rear corner was replaced by the original owner, he was backed into by a truck and tore the corner, instead of patching, it was replaced. <I agree with decision. There are no signs internally that it was replaced, the metal webbing behind the plastics is all straight with no signs of damage, car is perfectly straight.
The car was just at Acura/Honda for a defective spark plug, the electrode broke off and took out an exhaust valve on the way out. Block looked perfect, head was checked, fixed, and paid for by Acura! Compression is 240+/- 2-3 across the board, runs great with NO problems. This car is mechanically sound!
I would like to see 15,000 from this car, but of course its OBO.
Links about the car:
The defective spark plug- http://honda-tech.com/zerothread?id=1895613
Spoon Calipers/ JDM 16's- http://honda-tech.com/zerothread?id=1847433
Tuning by P1!!- http://honda-tech.com/zerothread?id=1803825
Hytech Exhaust- http://www.honda-tech.com/zerothread?id=1692321
There are about 100 pics in the thread above... I'll post some to highlight.
PM me, post here, or email me @ walker.james@gmail.com
JH4DC231XYS004242
124,000 miles
Mods:
Engine
Stock internals
Mugen Intake
Toda Header
Hytech Exhaust with Renault cat
Hondata IM gasket
VAFC
Tuned professionally by Jack at P1!
Transmission
JDM spec trans
4.7 FD
Cusco Clutch-pack differential
Skunk2 Shifter
Skunk2 Knob
Suspension/Brakes
Mugen Lowdowns
Mugen front strut bar
Password rear strut bar
Spoon Calipers w/Cobalt GT's and Autozone rotors front/rear
Stainless Steel brakelines
Safety
Autopower Rollbar
Certified Padding
Interior
Stock Front Seats
Stock Rear Seats
Stock Headunit
JDM Foglight switch
Aftermarket Speakers infinity front/ MB Quart rears
Two sets of floor mats- Black/Checkered
Exterior
Stock
Stock wheels
USDM Foglights
Spare set of JDM Gunmetal 16's
History- Some spoiled rich kid had it before me, commuted to and from college with it. Had some jenky springs and a DAC intake when I recieved it. Ever since my ownership its been meticuously maintained.
The bad- Car has the normal rock chips on the front end, couple of door dings, but still looks great clean. The drivers side rear corner was replaced by the original owner, he was backed into by a truck and tore the corner, instead of patching, it was replaced. <I agree with decision. There are no signs internally that it was replaced, the metal webbing behind the plastics is all straight with no signs of damage, car is perfectly straight.
The car was just at Acura/Honda for a defective spark plug, the electrode broke off and took out an exhaust valve on the way out. Block looked perfect, head was checked, fixed, and paid for by Acura! Compression is 240+/- 2-3 across the board, runs great with NO problems. This car is mechanically sound!
I would like to see 15,000 from this car, but of course its OBO.
Links about the car:
The defective spark plug- http://honda-tech.com/zerothread?id=1895613
Spoon Calipers/ JDM 16's- http://honda-tech.com/zerothread?id=1847433
Tuning by P1!!- http://honda-tech.com/zerothread?id=1803825
Hytech Exhaust- http://www.honda-tech.com/zerothread?id=1692321
There are about 100 pics in the thread above... I'll post some to highlight.
PM me, post here, or email me @ walker.james@gmail.com
