Page 1 of 1
Headgasket question
Posted: May 2nd, 2008, 5:34 pm
by Gross_00-0088
I'm rebuilding my block right now and I have already ordered my pistons for a 81.25mm bore the problem is I can not find a headgasket for that bore anywhere. Every place I have went goes from 81.00mm to 81.50mm. I was wondering if the 81.50mm will be fine for my bore. If any one knows where I can find an 81.25mm bore head gasket ( Preforably Cometic) It would be greatly appriciated. Thanks
Re: Headgasket question
Posted: May 12th, 2008, 3:05 pm
by Gross_00-0088
HELP PLEASE!!!
Re: Headgasket question
Posted: May 12th, 2008, 3:05 pm
by Gross_00-0088
HELP PLEASE!!!
Re: Headgasket question
Posted: May 13th, 2008, 3:43 am
by Erik B
Why'd you go 81.25 on a rebuild?
Re: Headgasket question
Posted: May 13th, 2008, 6:08 am
by Gross_00-0088
I just just went up a little cuz I know I'm Going to redue it later on down the road. I just had to get it running again.
Re: Headgasket question
Posted: May 22nd, 2008, 10:18 am
by mystican
King motorsports...call them...