Camber Kit

stayonpause · Post by **stayonpause** » October 21st, 2006, 2:24 pm

What would be a good camber kit to put on a TYPE R ? Should I go with aftermarket or OEM ? IF aftermarket ... which ones are good @ a reasonable price. And which one is the best ?

Bbasso · Post by **Bbasso** » October 21st, 2006, 3:21 pm

I have the Omni front kit that I won at Expo6, seems like a good quality. But I have yet to install it, I'm waiting on some other parts first.
Also is the Skunk version.

May I ask what you need it for?

Erik B · Post by **Erik B** » October 22nd, 2006, 9:44 am

deff not the ingals kit!

soulassassin13 · Post by **soulassassin13** » October 22nd, 2006, 1:41 pm

I went with Skunk2 for the front and I have no problems.

stayonpause · Post by **stayonpause** » October 22nd, 2006, 6:16 pm

Well my struts went out ... on my whole passenger side ... so I replaced all 4 with some koni sports shock absober ... Got my car align ... then about a week or two later ... my kar starts pulling to the side ... so i took it in to get align again ... the guys said i needed new cambers cuz the orginal on there is bad on the passenger front side ... so whats happen iz its eating my tires all uneven on the driver front side ... and those are sum expensive tires FALKEN AZENIS ... heard I could only get a max of 10k miles off those tires ... which i didnt find out till i got there ... but i had it special order so i couldnt say i didnt want it anymore ... but ever since i replace my shocks ... my whole suspension dont feel the same like it use to be I used my stock springs because around where i live theres alot of construction going on and floods ... so i didnt want it lower than 1.5" off the ground ... any suggestions ? Like I really want my suspension to be like it use to be or better ...

stayonpause · Post by **stayonpause** » October 22nd, 2006, 6:20 pm

Okay whats the different between skunk2 pro and just a reg. skunk2 ?

soulassassin13 · Post by **soulassassin13** » October 23rd, 2006, 9:47 pm

absolutely nothing from what I can see.

walker111 · Post by **walker111** » October 24th, 2006, 11:52 am

Skunk2 fronts, washers in the rear!

96TypeR · Post by **96TypeR** » December 2nd, 2006, 12:17 pm

i got the ingalls and it didnt straightin the wheels ebough so i had to go skunk2 also