Anyone ever done a 4x114 - 5x114 stud pattern conversion?

JDM96R · Post by **JDM96R** » October 29th, 2006, 5:29 pm

As subject states??????????????????? any1 done this b4?

naDC2R · Post by **naDC2R** » October 29th, 2006, 6:42 pm

yep, i have, on my 96 itr...im assuming thats what u have too?

JDM96R · Post by **JDM96R** » October 29th, 2006, 8:00 pm

yip i have a 96 itr (JDM). did u upgarde to a 98spec disk, hub, brakes etc??

naDC2R · Post by **naDC2R** » October 29th, 2006, 9:05 pm

99 spec, but mines usdm spec, so the axles were the same size, 32mm, so i didnt have to get custom axles to make it work with the jdm 98+ 36mm. Everything was direct bolt on, no modifications at all needed.

JDM96R · Post by **JDM96R** » October 29th, 2006, 9:47 pm

Interesting! Does anyone know if the 96itr (JDM) master brake cylinder is the same size as a 98spec itr????? I have a feeling the 98spec may be bigger but not sure???????
Cheers