poll: integra type r: forced induction or all motor?

Integra Type-R Discussion - Discuss general ITR information, technical information (including requests for technical/mechanical help/assistance), modifications, tuning, etc.
Locked

All motor vs FI

All motor
15
88%
FI
2
12%
 
Total votes: 17

00civicsiturbo7psi
New ITRCA Member
Posts: 42
Joined: October 16th, 2002, 6:04 pm
Location: Torrington, Ct. 06790

poll: integra type r: forced induction or all motor?

Post by 00civicsiturbo7psi »

like it says post replys to what you think a type r should be. if forced induction is the way or all motor. also if you have a type r thats all motor or forced induction tell us youre setup like internals bolt ons ect.... and youre 1/4 mile times and dyno #s if you have any. thanks and hope to see some good setups from each side.
pUrExTc
ITRCA Member
Posts: 294
Joined: October 7th, 2002, 5:04 pm
Location: Cerritos, CA
Contact:

Post by pUrExTc »

why would u f/i any car with a compression ratio like the type-r's? it's definately not built to have any type of f/i.
'98 Acura Integra Type-R
'03 Honda CBR600RR
Surgeon General's Warning: It's OK to Smoke V8's
ITR1140
New ITRCA Member
Posts: 19
Joined: October 18th, 2002, 5:37 pm
Location: Vancouver, Canada
Contact:

Post by ITR1140 »

type rs are made to be n/a, just look at the comp ratio...
2000 Phoenix Yellow Integra Type R
Kramar
New ITRCA Member
Posts: 12
Joined: September 20th, 2002, 4:30 pm

Post by Kramar »

i'll take N/A...
00civicsiturbo7psi
New ITRCA Member
Posts: 42
Joined: October 16th, 2002, 6:04 pm
Location: Torrington, Ct. 06790

Post by 00civicsiturbo7psi »

anyone have setups or 1/4 mile times for thier r to post? even dyno sheets and lists of mods.
ITR1140
New ITRCA Member
Posts: 19
Joined: October 18th, 2002, 5:37 pm
Location: Vancouver, Canada
Contact:

Post by ITR1140 »

00civicsiturbo7psi wrote:anyone have setups or 1/4 mile times for thier r to post? even dyno sheets and lists of mods.
This is my friends setup...

2000 Civic SiR
AJR Cold air intake
Ported throttle body
Type One 4-2-1 exhaust manifold
5Zigen border 304 speed catback
B18 block
ITR intake manifold
Engine and transmission mount set
81.5mm Pistons (12.4:1 CR)
Spoon intake and exhaust cams
Spoon cam gears
ITR valve springs
Spoon flywheel
Spoon clutch
Spoon SW-388 15" with Advan A-032
Tein HA coilovers
Kazz 1.5 way LSD
Short shifter
Apexi V-AFC
No A/C

He ran 13.711@103.11mph
2000 Phoenix Yellow Integra Type R
Locked