Page 1 of 1
poll: integra type r: forced induction or all motor?
Posted: October 18th, 2002, 11:25 am
by 00civicsiturbo7psi
like it says post replys to what you think a type r should be. if forced induction is the way or all motor. also if you have a type r thats all motor or forced induction tell us youre setup like internals bolt ons ect.... and youre 1/4 mile times and dyno #s if you have any. thanks and hope to see some good setups from each side.
Posted: October 18th, 2002, 1:06 pm
by pUrExTc
why would u f/i any car with a compression ratio like the type-r's? it's definately not built to have any type of f/i.
Posted: October 18th, 2002, 5:46 pm
by ITR1140
type rs are made to be n/a, just look at the comp ratio...
Posted: October 18th, 2002, 6:04 pm
by Kramar
i'll take N/A...
Posted: October 18th, 2002, 7:23 pm
by 00civicsiturbo7psi
anyone have setups or 1/4 mile times for thier r to post? even dyno sheets and lists of mods.
Posted: October 18th, 2002, 10:16 pm
by ITR1140
00civicsiturbo7psi wrote:anyone have setups or 1/4 mile times for thier r to post? even dyno sheets and lists of mods.
This is my friends setup...
2000 Civic SiR
AJR Cold air intake
Ported throttle body
Type One 4-2-1 exhaust manifold
5Zigen border 304 speed catback
B18 block
ITR intake manifold
Engine and transmission mount set
81.5mm Pistons (12.4:1 CR)
Spoon intake and exhaust cams
Spoon cam gears
ITR valve springs
Spoon flywheel
Spoon clutch
Spoon SW-388 15" with Advan A-032
Tein HA coilovers
Kazz 1.5 way LSD
Short shifter
Apexi V-AFC
No A/C
He ran 13.711@103.11mph